HVAC Design is an active strategy that can help reduce energy waste thanks to mechanical heating, ventilation, and air conditioning systems.
The first equipment and techniques were developed in the 1930s and 40s and solidified by the 50s and 60s. Since then, gradual improvements in efficiency, comfort, and reliability made HVAC an important part of modern life: it is used in residential structures, industrial and office buildings, hospitals, vehicles such as cars, trains, airplanes and much more.
wHAT CAN HVAC SYSTEMS DO?
While not all HVAC systems are the same, most of them operate on some similar basic principles.
Central cooling: arguably the most common type of HVAC system, consists of an outdoor condenser coil and compressor, and an indoor evaporator coil. The secret to central cooling comes down to the refrigerant that’s pumped through the system by the compressor. Heat from the air in your home transfers to the refrigerant as the refrigerant passes through the evaporator coil. This transfer cools the coil, which air then blows across, travels through a duct network, and into your home.
Central heating: rather than relying on refrigerant, warms combustion gases that are then passed through a heat exchanger. Air blows across the heat exchanger, warming it before it spreads throughout your home. In addition to the heating and cooling components of your HVAC system, filters in your system catch potentially harmful particles before air distributes through your home.
Ventilation: the process of exchanging air from indoor to outdoor.
Moisturizing: refers to the process of increasing the relative humidity through the addition of water vapor into the system.
Dehumidifying: the prose removes moisture from space.
Cleaners: air purification to remove flying dust and dirt.
HVAC SYSTEM components
The thermostat is an important component of the HVAC system because that’s what triggers the entire system to start cooling or heating. It’s
located centrally in the home and programmed according to the occupants’ preferences.
image source: https://www.dscr.com/blog/low-set-thermostat-town/
The furnace is located in the home and its job is to heat the air that comes through the system. This is most often done through combustion in which oil, natural gas, coal or propane is burned.
The evaporator coil works during the summer to cool the air in the system. It’s on the top or side of the furnace inside the home.
The heat exchanger’s role is opposite that of the evaporator coil. It pulls in cold air and heats it so that it can be circulated throughout the home just as the cool air from the evaporator coil is circulated.
The condensing unit is located outside the home and is connected to the evaporator coil. The condenser contains refrigerant gas which is cooled through heat exchange. The gas is compressed and condensed into liquid and sent through lines to the evaporator coil. The liquid gas is then converted back to a gaseous form and sent back to the condenser so that the process is repeated over and over.
The refrigerant lines are what carry the refrigerant between the evaporator coil and the condensing unit. They’re made of either copper or aluminum so that they can work in extremely hot or cold weather.
Ducts are an important component of HVAC in Alpharetta that sometimes get overlooked. The ducts run throughout the house to deliver air to each room. A properly built duct network is essential for the HVAC system to run effectively.
Finally, vents are cut into the ducts to allow the air to enter the room. The vent, or register, is made of slatted metal to channel the air a certain direction into the room.
info source: https://en.wikipedia.org/wiki/Heating,_ventilation,_and_air_conditioning